Flowlogic Automatic; Fabric Softener - GE PTAN9150MWW Manuel De L'utilisateur

FlowLogic automatic drawer dispenser.
Your washer is equipped with an automatic dispensing system, comprised of a drawer with 3 compartments:
bleach detergent softener
Detergent
Add the amount of powder or liquid low suds detergent in the compartment, as recommended by the manufacturer and
according to the size of the load. You should not put the detergent directly on the clothes in the washer.
· For powder detergent: Install the divider in the front position. Put the detergent selection blue wall, that is located at the
end of the dispenser, in the front position, as shown in Figure 1.
· For liquid detergent: Install the divider in the back position. Put the detergent selection blue wall , that is located at the
end of the dispenser, at the back position, as shown in Figure 2.
Place the amount of liquid detergent without exceeding the maximum level indicated.

Fabric Softener

Pour fabric softener into the designated compartment without filling beyond the mark.
Note: in order for the fabric softener to be dispensed you must select the DEEP RINSE option. Please refer to the Options
section of this manual.
Liquid bleach
Pour liquid bleach into the designated compartment without filling beyond the mark.
Check clothing care labels for specialinstructions. Use less for smaller loads.
Do not dilute bleach. Bleach will be added automatically diluted to avoid direct
contact with the clothes. Use only this compartment, do not add bleach directly
onto clothes.
IMPORTANT:
To avoid any potential leftover bleach mixture being dispensed in a subsequent
cycle, it is strongly recommended to verify that the bleach compartment of the
dispenser is free of any leftover bleach and water mixture. If there is some
leftover bleach mixture, please empty the contents to avoid any damage to clothes
that cannot tolerate bleach.
Figure 1 Figure 2
11