GE PTAN9150MWW Manuel De L'utilisateur page 16

Masquer les pouces Voir aussi pour PTAN9150MWW:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before you call for service...
PERFORMANCE
Clothes too wet
Coloured sp o ts
Grayed or yellowed
clothes
Lint or residue on
clothes
Pilling
Snags, holes, tears, rips
or excessive wear
Wrinkling
16
Possible Causes
Incorrect cycle selected
Wash load out of balance
Incorrect use of fabric
softener
Dye transfer
Detergent amount
Hard water
Water is not hot enough
Washer is overloaded
Detergent is not dissolving
Dye transfer
Clothes are air or line dried
Incorrect sorting
Washing too long
Overloading
Incorrect use of fabric
softener
Result of normal wear on
poly-cotton blends and
fuzzy fabrics
Pins, snaps, hooks, sharp
buttons, belt buckles,
zippers and sharp objects
left in pockets
Undiluted chlorine bleach
Chemicals like hair bleach or
dye, permanent wave solution
Improper sorting
Overloading
Incorrect wash and
dry cycles
Repeated washing in
water that is too hot
What To Do
• Make sure the cycle selected matches the load you are
washing. Some fabrics will feel wetter when rinsed with cold water.
• Redistribute load in washer and run through Drain & Spin cycle.
• Check fabric softener package for instructions and follow
directions for using dispenser.
• Make sure you have selected the Deep Rinse option.
• Pretreat stain and rewash.
• Sort whites or lightly coloured items from dark colours.
• Be sure to follow detergent manufacturer's directions.
• Use a water conditioner or install a water softener.
• Make sure water heater is delivering water at
120°F–140°F (48°C–60°C).
• Loosely load clothes no higher than the line in the the wash
basket ring
. For best results, load items around the outside
of the infusor.
• Add detergent to the wash basket before you load clothes.
• Sort clothes by color. If fabric label states wash separately,
unstable dyes may be indicated.
• If you do not dry your clothes with a clothes dryer, your
clothes may retain more lint.
• Separate lint producers from lint collectors.
• Wash small loads for a shorter time than larger loads.
• Loosely load clothes no higher than the line in the the wash
basket ring
. For best results, load items around the outside
of the infusor.
• Check fabric softener package for instructions and follow
directions for using dispenser.
• While this is not caused by the washer, you can slow
the pilling process by washing garments inside out.
• Fasten snaps, hooks, buttons and zippers.
• Remove loose items like pins, objects in pockets
and sharp buttons.
• Turn knits (which snag easily) inside out.
• Check bleach package instructions for proper amount.
• Never add undiluted bleach to wash or allow clothes
to come in contact with undiluted bleach.
• Rinse items that may have chemicals on them before
washing.
• Avoid mixing heavy items (like work clothes) with light items
(like blouses).
• Try a fabric softener.
• Loosely load clothes no higher than the line in the the wash
basket ring
. For best results, load items around the outside
of the infusor.
• Match Cycle selection to the type of fabric you are washing
(especially for easy care loads).
• Wash in warm or cold water.

Publicité

Table des Matières
loading

Table des Matières