Dvd To Videotape Duplication 41 - Philips MX5100VR Manuel Du Propriétaire

MX5100VR.qxd 6/04/2004
Follow the steps below to copy a DVD to a videotape.
This will be possible only if the DVD is not copy protected.
Before you begin:
Put a videotape in the cassette compartment. Make sure the tape's
record tab is intact and the tape is long enough to record the
DVD.
Put the DVD you want to copy in the disc tray.
Press VCR so the red VCR light appears on the front of
the System.
Turn on the TV.
1
Point the remote control at the System. Press Number
buttons 0, 0, 3. "DISC" will appear on the TV screen in the
top right corner briefly.The DVD logo will also appear.
2
Press MODE/SPEED until the desired tape speed (SP
or SLP) appears briefly in the lower left corner of the
TV screen.
3
Press REC
will appear on the front of the System.
4
Press DVD. Press PLAY
5
To pause the recording, press VCR, then press PAUSE
once. The red RECORD light will flash. To resume
recording, press REC I or press PAUSE k again. The
red RECORD light will come on again.
6
To stop recording, press VCR, then press STOP
3:37 PM Page 41

DVD to Videotape Duplication 41

DISC
Details about tape speed are on page 77.
I to start recording. The red RECORD light
B to play the DVD.
TIMER SET
SETUP/ AUDIO/
SUBTITLE
PROG BAND
REC
DISPLAY
C-RESET
SKIP/
CLEAR
CH
TITLE MODE/SPEED
4
TUNER
DVD
DISC
MENU
6
STOP
REW
5
PAUSE
1 2 3
4 5 6
SEARCH MODE
7 8 9
REPEAT
+10 0
SURROUND SOUND VOLUME
–
PHILIPS
k
C.
Helpful Hints
• A Timer Recording is not possible
during DVD to Videotape
duplication.
• You cannot select Tuner mode
during DVD to videotape
duplication.
• The recording will not be clear if
the DVD has copyright protection.
STANDBY-ON
3,5
ANGLE
ZOOM
SKIP/
CH
2
RETURN
VCR
5-6
OK
4
PLAY
FF
SLOW
VCR/TV
1
REPEAT
A-B
+