First-Time Setup 19 - Philips MX5100VR Manuel Du Propriétaire

MX5100VR.qxd 6/04/2004
Before turning on your System, make sure batteries are in the
remote control and the TV and System are connected correctly.
You cannot program TV channels at the System if you are using a
Cable Box or a Satellite Receiver.You will change channels at the
Cable Box/Satellite Receiver.
1
Turn on the TV. Set it to channel 3 or 4 or its
AUDIO/VIDEO IN channel,
connected the System to a TV.
2
Press STANDBY-ON
press VCR. The red VCR light and the red STANDBY-ON
light will appear on the front of the System.This display will
appear.
LANGUAGE SELECT
ENGLISH
B
FRANCAIS
ESPA„OL
These menus may not appear if you have already
turned on the System (to find the Audio/Video In
channel of the TV, for example). Follow the steps on
page 28 to set up TV channels and page 32 to select a
language for the VCR menus.
3
Press o or p to select English, French, or Spanish as
the language for VCR on-screen displays and menus.
Then, press B.
AUTO SET UP
4
Press B to begin channel programming. AUTO SETUP
will flash on the TV screen during the channel search.The
System will memorize all available channels.When channel
programming is complete, the lowest available channel will
appear on the TV.These channels will be available when you
want to watch TV while the System is in VCR mode.To put
the System in VCR mode, press VCR so the red VCR light
appears. Use the SKIP i /CH o and SKIP j /CH p
buttons to select memorized channels.To select non-
memorized channels, use the Number buttons.
3:37 PM Page 19
depending on how you
y y to turn on the System, then
[ON]

First-time Setup 19

1
Turn on the TV.
STANDBY-ON
TIMER SET
SETUP/ AUDIO/
SUBTITLE ANGLE
PROG BAND
REC DISPLAY ZOOM
C-RESET
SKIP/ SKIP/
CLEAR
CH CH
TITLE MODE/SPEED RETURN
TUNER
DVD VCR
DISC
OK
MENU
STOP PLAY
REW FF
PAUSE
SLOW
1 2 3
VCR/TV
4 5 6
SEARCH MODE
7 8 9
REPEAT REPEAT
+10 0 A-B
SURROUND SOUND VOLUME
– +
PHILIPS
Helpful Hints
• To skip this feature and play a
tape immediately, insert a tape
with its record tab removed.
• To skip step 3, press DISC/MENU.
VCR menus and displays will be in
English.
• If you try to program channels
when there is no antenna or Cable
TV signal connected to the
System's TV ANTENNA IN jack,
programming will stop. AUTO SET
UP will stop flashing. Connect an
antenna or Cable TV signal to the
System's TV ANTENNA IN jack
and press B again.
• Repeat this process if the power
fails for more than 30 seconds.
• To stop the Channel Setup while
AUTO SET UP is flashing, press
DISC/MENU.
2
3-4