Videotape Recording - Philips MX5100VR Manuel Du Propriétaire

MX5100VR.qxd 6/04/2004

34 Videotape Recording

Read and follow the steps below to record a television program onto a
videotape. Before you begin, make sure the System is in VCR
mode. Press VCR so the red VCR light appears on the front of
the System.
1
Turn on the TV and set it to channel 3 or 4 or the
Video In channel.
using the supplied audio and video cables, select your TV's
Video In channel. Details are on page 11.
If you connected the System to the TV using the supplied RF
coaxial cable, choose channel 3 (or 4) at the TV.
Details are on pages 8-10.
2
Insert a tape with its record tab intact into the
cassette compartment of the System.
begins, press STOP C.
3
Press MODE/SPEED until the desired tape speed (SP
or SLP) appears briefly on the TV screen and the
System's display panel.
Details about tape speed are on page 77.
4
Press SKIP
Number buttons to select the TV channel to record.
5
Press REC
will appear on the front of the System.
6
To pause the recording, press PAUSE
RECORD light will flash. To resume recording, press REC
I or press PAUSE k again. The red RECORD light will
come on again.
7
To stop recording, press STOP
Recording Prevention
Video Cassettes have record tabs to ensure that recordings are not
accidentally erased.
1
To prevent recording, break off the tab with a
screwdriver.
2
To allow recording, cover the hole with clear tape.
3:37 PM Page 34
If you connected the System to the TV
i /CH o or SKIP j /CH p or the
I to start recording. The red RECORD light
C.
Remove the
tab to prevent
recording.
1
2
5
3
If tape playback
7
6
k once. The red
• Other recording options are on
pages 35-41.
• The VCR will record in a preset
volume.
• Pause will switch to Stop after five
minutes to protect the VCR and the
tape from damage.When a
recording is paused, review the
pause time remaining with the I
marks on the TV screen. Each I
mark equals one minute remaining.
During the last minute of paused
Cover the
recording, the I mark will flash.
hole to allow
• If any menu is on the TV screen, the
recording.
REC I button on the remote does
not function. Press C-RESET/CLEAR
to remove the menu.Then, press
REC I. Or, use the RECORD I
button on the front of the System.
Turn on the TV.
Insert a tape in the System.
STANDBY-ON
TIMER SET
SETUP/ AUDIO/
SUBTITLE ANGLE
PROG BAND
REC DISPLAY ZOOM
4
C-RESET
SKIP/ SKIP/
CLEAR
CH CH
TITLE MODE/SPEED RETURN
TUNER
DVD VCR
DISC
OK
MENU
STOP PLAY
REW FF
PAUSE
SLOW
1 2 3
VCR/TV
4 5 6
SEARCH MODE
7 8 9
REPEAT REPEAT
+10 0
A-B
SURROUND SOUND VOLUME
– +
Helpful Hints