One-Touch Recording - Philips MX5100VR Manuel Du Propriétaire

MX5100VR.qxd 6/04/2004

36 One-Touch Recording

One-Touch Recording (OTR) lets you set a timed recording 30
minutes to eight hours long. Before you begin:
Place the System in VCR mode. Press VCR so the red VCR light
appears on the front of the System.
Select a recording speed (SP, SLP) with the MODE/SPEED button.
Put a videotape in the cassette compartment. Make sure the tape's
record tab is intact and the tape is long enough to record the
program(s).
1
Press SKIP
Number buttons to select the channel you want to
record.
2
Press RECORD
desired recording length (30 minutes to eight hours)
appears on the TV screen. Recording will begin.The
RECORD light and the TIMER REC light will appear on the
front of the System.
OTR (0:30)
SP
Stopping an OTR
To stop an OTR before recording is finished, press STOP C on the
remote control or STOP/EJECT C A on the front of the System.
To cancel the OTR but continue recording, press RECORD I on
the front of the System repeatedly until REC appears in the upper
left corner of the TV screen.
When an OTR finishes, the System will switch to DVD mode and/or
turn itself off.The TIMER REC light will flash because the VCR of the
System is still on standby for timer recordings. Press TIMER SET on
the remote or STOP/EJECT C A on the System to cancel timer
standby and use the VCR of the System normally again.
3:37 PM Page 36
i /CH o or SKIP j /CH p or the
I on the front of the System until the
STANDBY-ON
TIMER SET
SETUP/ AUDIO/
SUBTITLE ANGLE
PROG BAND
REC
DISPLAY ZOOM
C-RESET
SKIP/ SKIP/
CLEAR
CH CH
TITLE MODE/SPEED RETURN
TUNER
DVD VCR
DISC
OK
MENU
STOP PLAY
REW FF
PAUSE
SLOW
1 2 3
VCR/TV
4 5 6
SEARCH MODE
7 8 9
REPEAT REPEAT
+10 0
A-B
SURROUND SOUND VOLUME
– +
2
Press RECORD I on the
front of the System.
Helpful Hints
• The remaining recording time will
appear on the display panel. Press
DISPLAY to see it on the TV screen.
• To change the recording length
while an OTR is in progress, press
RECORD I on the front of the
System.
• You cannot start a timed OTR with
the REC I button on the remote.
• You cannot pause an OTR.
• If the end of the tape is reached
during an OTR, the VCR will stop
recording, eject the tape, and
switch to DVD mode and/or turn
off. The TIMER REC light will flash.
Press TIMER SET on the remote or
STOP/EJECT CA on the System
to cancel timer standby and use
the VCR again.
• If you press TIMER SET for a
Timer Recording, the OTR will stop
immediately.The System will switch
to DVD mode or turn off for the
recording.
1