Video Cassette Playback - Philips MX5100VR Manuel Du Propriétaire

MX5100VR.qxd 6/04/2004

20 Video Cassette Playback

Read and follow the steps below to play a tape.
1
Turn on the TV. Set it to channel 3 or 4 or its
AUDIO/VIDEO IN channel.
connected the System to a TV. Details are on pages 8-11.
2
With the System's power off, insert a tape in the
cassette compartment.
will appear on the front of the System. If the tape's record tab
has been removed, playback will start automatically.
Or, if the System's power is already on, press VCR to put the
System in VCR mode.The red VCR light will appear on the
front of the System.
3
If play does not start automatically, press VCR, then
press PLAY
4
Press STOP
5
Press REW
6
After the tape stops, press STOP/EJECT
front of the System to remove the tape.
3:37 PM Page 20
This depends on how you
The STANDBY-ON and VCR lights
B.
C to stop playback.
h to rewind the tape.
1
Turn on the TV.
2
Insert a tape in the System.
4
5
C A on the
6
Press STOP/EJECT C A on
the System.
• Other tape playback features are
on pages 42-46.
• If AUTO REPEAT is ON, playback
will begin when you insert a tape,
even when the record tab is intact.
Details are on page 42.
• You must connect the System to a
TV using the RF coaxial cable or
the audio/video cables in order to
use the VCR features.These
hookups are explained on pages
eight and 11.
• You cannot use the VCR when the
System is in Tuner mode. If you fast
forward, rewind, or eject a videotape,
you may hear noise through the
speakers or some displays may be
incorrect.
• You cannot use the Tuner when the
System is in VCR mode. Make sure
you stop tape play before putting
the System in Tuner mode.
STANDBY-ON
TIMER SET
SETUP/ AUDIO/
SUBTITLE ANGLE
PROG BAND
REC DISPLAY ZOOM
C-RESET
SKIP/ SKIP/
CLEAR
CH CH
TITLE MODE/SPEED RETURN
3
TUNER
DVD VCR
DISC
OK
MENU
STOP PLAY
REW FF
PAUSE
SLOW
1 2 3
VCR/TV
4 5 6
SEARCH MODE
7 8 9
REPEAT REPEAT
+10 0
A-B
SURROUND SOUND VOLUME
– +
Helpful Hints