Remote Control Setup; Putting Batteries In The Remote Control; Using The Remote Control - Philips MX5100VR Manuel Du Propriétaire

MX5100VR.qxd 6/04/2004
18 Speaker Setup (cont'd), Remote Control Setup
Speaker setup
You can hang the front, center and rear (Surround) speakers on a
wall. Each speaker needs one screw (not supplied) for mounting.
Use the type and size of screw as shown at right.
1
Attach a supplied bracket to the back of each speaker
with one of the supplied screws.
2
Drive a screw into the wall. Make sure the screw and the
wall can support 11 lbs. (5 Kg.) Drive the screw until the
screw head extends about 0.1" (3.5 mm) from the wall.
3
Hook the slot in the speaker's bracket onto the wall-
mounted screw. Tuck the extra speaker wire into the
recessed area behind the speaker.
Caution
• Check the stability of the ceiling or wall. Philips is not liable for
accidents caused by insufficient stability of the ceiling or wall or for
improper mounting.
• The speaker may fall due to unstable mounting.
• If you need assistance, contact Philips.
• Do not modify or change the fittings of the supplied speakers,
mounting brackets, and screws. Use these brackets to mount the
supplied speakers only. Do not load anything else on these fittings.
• Do not step on or hang from the speakers. Pay special attention to
small children to ensure their safety.

Putting Batteries in the Remote Control

1
Remove the battery compartment lid
the remote control by pressing the tab, then lifting the lid.
2
Place two AA batteries inside the battery
compartment
3
Replace the battery compartment lid.

Using the Remote Control

Point the remote control at the System's remote sensor (marked
IR, see page 24) when using the remote to operate the System. Do
not point the remote at the TV.
Do not put objects between the remote and the System.
Recycling Guidelines/Battery Safety
Your new product and its packaging contain materials that can be
recycled and reused. Specialized companies can recycle your product
to increase the amount that needs to be properly disposed.Your
product uses batteries that should not be thrown away when depleted
but should be disposed of as small chemical waste. Please find out
about the local regulations on disposal of your old product, batteries,
and packaging whenever you replace existing equipment.
Battery Usage CAUTION - To prevent battery leakage that may
result in bodily injury, property damage, or damage to the unit:
Install ALL batteries correctly, with the + and - markings on the
battery aligned as indicated on the unit;
Do not mix batteries, for example, old with new or carbon with
alkaline; and
Remove batteries when the unit will not be used for a long time.
3:37 PM Page 18
with their + and – ends aligned as indicated.
on the bottom of
1
2
3
1
2
3