Remote Control Setup; Putting Batteries In The Remote Control; Using The Remote Control - Philips DVD750VR Mode D'emploi

H9421CD/DVD750(EN).pgs1-51.QX3 03.4.11 11:29 AM Page 16

16 Remote Control Setup

Putting Batteries in the Remote Control

1
Remove the battery compartment lid on the bottom
of the remote control by pressing the tab, then lifting the
lid.
2
Place two AA batteries inside the battery compart-
ment with their + and – ends aligned as indicated.
3
Replace the battery compartment lid.

Using the Remote Control

Point the remote control at the DVD/VCR's remote sensor
(marked IR, see page 22) when using the remote to operate the
DVD/VCR. Do not point the remote at the TV.
Do not put objects between the remote and the DVD/VCR.
Recycling Guidelines/Battery Safety
Your new product and its packaging contain materials that can
be recycled and reused. Specialized companies can recycle your
product to increase the amount that needs to be properly dis-
posed.Your product uses batteries that should not be thrown
away when depleted but should be disposed of as small chemical
waste. Please find out about the local regulations on disposal of
your old product, batteries, and packaging whenever you replace
existing equipment.
Battery Usage CAUTION - To prevent battery leakage that may
result in bodily injury, property damage, or damage to the unit:
Install ALL batteries correctly, with the + and - markings on the
battery aligned as indicated on the unit;
Do not mix batteries, for example, old with new or carbon with
alkaline; and
Remove batteries when the unit will not be used for a long
time.
1
2
3