Disc Playback 21 - Philips MX5100VR Manuel Du Propriétaire

MX5100VR.qxd 6/04/2004
Before you begin, turn on the TV and set it to the correct Video In
channel. Details are on pages 7-15.
1
Press STANDBY-ON
2
Press DVD so the red DVD light appears on the front
of the System.
3
Press OPEN/CLOSE
front of the System) to open the Disc tray.
4
Place a Disc into the tray.
one side, place the Disc in the tray with the label facing up and
the shiny side facing down.
Some DVDs are recorded on both sides. Make sure the label
of the side you want to play is facing up.
5
Press PLAY
DVD menu appears instead, see page 54.With some Audio
CDs, play will not begin unless you press PLAY B.
You also can press OPEN/CLOSE A or press the tray toward
the System to close the tray.
6
Press STOP
Remember, the DVD Player of this
System will play only certain Discs.
See page six for details.
3:37 PM Page 21
y y to turn on the System.
A (to the right of the disc tray on the
If the DVD is recorded on only
B. The tray will close and play will begin. If a
C to stop playback.

Disc Playback 21

STANDBY-ON
TIMER SET
SETUP/ AUDIO/
SUBTITLE ANGLE
PROG BAND
REC DISPLAY ZOOM
C-RESET
SKIP/ SKIP/
CLEAR
CH CH
TITLE MODE/SPEED RETURN
2
TUNER
DVD VCR
DISC
OK
MENU
6
STOP PLAY
REW FF
PAUSE
3
Press OPEN/CLOSE A on
the front of the System.
4
Insert a Disc.
Helpful Hints
• An "X" may appear at the top
right corner of the TV screen when
you try a feature. Either the feature
is not available on the Disc, or the
System cannot access the feature
at this time.This does not indicate
a problem with the System.
• If a Disc is dirty or scratched, the
picture may appear distorted or
play may stop. Remove the Disc
and turn off the System.
Disconnect the power cord, then
reconnect it. Clean the Disc, then
turn on the System again and
reinsert the Disc.You may need to
repeat the System's setup because
of the temporary power loss.
• When the DVD or CD light
appears on the display panel, the
Disc is loaded and ready to play.
• When you press OPEN/CLOSE A
or PLAY B (DVD) on the front of
the System when the power is off,
the System will turn on in DVD
mode. Otherwise, the System will
turn on in the mode in which it
was turned off.
• Do not use the DVD Player
features when the System is in
Tuner mode.You may hear noises
through the speakers or the
displays may be incorrect.
1
5