Dvd To Videotape Duplication 39 - Philips DVD750VR Mode D'emploi

H9421CD/DVD750(EN).pgs1-51.QX3 03.4.11 11:29 AM Page 39
Follow the steps below to copy a DVD to a videotape. This will
be possible only if the DVD is not copy protected.
Before you begin:
Put a videotape in the cassette compartment. Make sure the
tape's record tab is intact and the tape is long enough to record
the DVD.
Put the DVD you want to copy in the disc tray.
Press VCR so the green VCR light appears on the front of the
DVD/VCR.
Turn on the TV.
1
Point the remote control at the DVD/VCR. Press Number
buttons 0, 0, 3. "DISC" will appear on the TV screen.
2
Press SPEED until the desired tape speed (SP or
SLP) appears briefly on the screen. Details about tape
speed are on page 76.
3
Press RECORD
light will appear on the front of the DVD/VCR.
4
Press DVD. Press PLAY B to play the disc.
5
To pause the recording, press VCR, then press PAUSE
k once. The red RECORD light will flash. To resume
recording, press RECORD
The red RECORD light will come on again.
6
To stop recording, press VCR, then press STOP C.

DVD to Videotape Duplication 39

DISC
to start recording. The red RECORD
I
or press PAUSE k again.
I
STANDBY-ON
SEARCH MODE DISPLAY
REPEAT REPEAT AUDIO
A-B
SUBTITLE ZOOM ANGLE SKIP / CH
RETURN TITLE CLEAR/RESET SLOW
4
VCR/TV
DVD VCR
SYSTEM DISC/VCR
MENU MENU
OK
6
STOP PLAY PAUSE
TIMER SET VCR Plus+ RECORD
2
SPEED
1 2 3
4 5 6 7
1
8 9 0 +10
3,5
Helpful Hints
• A timer recording is not possible
during DVD to videotape
duplication.
• You cannot copy a DVD to a
videotape if you are using
Progressive Scan. Details are on
page 12.
5,6
5