Philips DVD750VR Mode D'emploi page 9

H9421CD/DVD750(EN).pgs1-51.QX3 03.4.11 11:29 AM Page 9
This connection will let you use the features of both the VCR and the DVD Player.
1
Cable Box/Satellite Receiver
Cable
Signal
RF coaxial cable
Connections
1
Connect a Cable TV or Satellite signal to the IN
jack on the Cable Box/Satellite Receiver.
2
Use an RF coaxial cable (as the one supplied) to
connect the OUT jack on the Cable Box/Satellite
Receiver to the ANT -IN (Antenna In) jack on the
DVD/VCR.
3
Use a second RF coaxial cable to connect the ANT -
OUT (Antenna Out) jack on the DVD/VCR to the
TV's Antenna In jack.
Remember...
There are two ways to connect your Cable Box/Satellite Receiver
to the DVD/VCR.With the connection on this page:
Select TV channels at the Cable Box/Satellite Receiver, not the
DVD/VCR.To record or view TV channels, follow these steps:
1) Press VCR to put the DVD/VCR in VCR mode.The green
VCR light will appear on the front of the DVD/VCR.
2) Press SKIP3/CHo or SKIP
to the Cable Box/Satellite Receiver output channel (03 or 04).
3) Set the TV to the DVD/VCR's output channel (03 or 04).The
DVD/VCR's output channel is channel 3 when the DVD/VCR is
new.To change it from 3 to 4, press and hold the (VCR) PLAY
B button on the DVD/VCR for 3-5 seconds during tape play-
back. For more details, see step 4 on page 8.
4) Select the channel you want to view/record at the Cable
Box/Satellite Receiver.
You may not view a channel other than the one you are recording.
You can only program a timer recording for one channel at a time.
Set your Cable Box/Satellite Receiver to the channel you want to
record.When you enter the channel you want to record in a
timer recording, select channel 03 or 04 (the Cable Box/Satellite
Receiver output channel). (This is step 7 on page 38.) Leave the
Cable Box/Satellite Receiver on for a timer recording.
If you use the VCR Plus+ Programming system, set the
Cable/TV channel to 03 or 04 (Cable Box/DBS output channel)
for every VCR Plus+ channel in the VCR Plus+ Cross Reference
Map.You must set the Cable Box/DBS to the channel you want
to record; leave the Cable Box/DBS on for the timer recording.
Details are on page 40.
DVD/VCR to Cable Box or Satellite Receiver and TV
Using only basic RF coaxial cables
2
IN
OUT
/CHp to set the DVD/VCR
Hookups (cont'd) 9
DVD/VCR
DVD/VCR VCR
AUDIO OUT AUDIO IN
ANT-IN
L L
R R RF coaxial cable
VIDEO OUT VIDEO IN
ANT-OUT
• If your Cable Box or Satellite
Receiver has Audio and Video Out
jacks, use audio and video cables
to connect them to the VCR
AUDIO IN and VIDEO IN jacks on
the rear of the DVD/VCR.You will
not need the RF coaxial cable con-
nection between the Cable
Box/Satellite Receiver and the
DVD/VCR as described at step 2.
7 5
A N T
/
C A B
L E
DVD
S-VIDEO COMPONENT AUDIO DIGITAL
OUT VIDEO OUT OUT AUDIO OUT
Y
C B L
COAXIAL
C R
R
3
TV's ANTENNA
IN Jack
Helpful Hint