Steam Operation; Noises; Steam Cooking - Thermador Professional Série Guide D'utilisation Et D'entretien

Stop Function
The accessories can be pulled out approximately halfway
until they lock in place. The stop function prevents the
accessories from tilting when they are pulled out. The
accessories must be inserted into the oven cavity
correctly for the tilt protection to work properly.

Steam Operation

Food can be cooked very gently using steam. With some
heating modes, you can prepare food with steam
assistance. In addition, the Proof, Defrost and Reheat
modes are available.
WARNING
9
RISK OF SCALDING
Hot steam can escape when you open the
appliance door. Steam is not visible at certain
temperatures. Do not stand too close to the
appliance when opening it. Open the appliance
door with caution. Keep children away.

Noises

You will hear a humming noise while the pump is in
operation and after switching it off. This noise is caused
by the pump function test. It is a normal operating noise.
You will also hear this noise after running non-steam
modes when the oven is turned off. This is normal.

Steam Cooking

During steaming, hot steam surrounds the food and
therefore prevents loss of nutrients from the food. The
shape, color and typical aroma of the dishes are retained
as a result of this preparation method. With steam,
flavors are not affected when cooking a whole meal at
the same time.
When inserting the wire rack, ensure that the stop catch
is at the rear and is facing downwards. The open side
‚
must be facing towards the appliance door and the
curvature must be facing downwards
Note: If the water tank runs dry during steaming,
operation is interrupted. Fill the water tank. After the
water tank is reinserted, Steam cooking will resume.
Your oven has five modes for Steam cooking:
Steam
‹
▯
Steam Convection
§
▯
Proof
Œ
▯
Defrost
"
▯
Reheat
¨
▯
Setting
Example: Set heating mode Steam
(100°C) for 20 minutes.
Refill water tank.
1.
Note: Only switch on steaming once the oven cavity
has cooled down completely (to room temperature).
Turn the function selector to STEAM.
2.
Turn the temperature selector to the required
3.
temperature.
.
¾
with 212°F
‹
23