Securing The Child - NORAUTO 2274270 Mode D'emploi

CAUTION: After the ISOFIX installation check if the child restraint is securely fitted. If
the child restraint is not stable and is shaking, reinstall.
4. Pull out the support leg, and adjust it to the maximum angle.
5. Press the adjust button of the support leg, and adjust the length of the support
leg so that it is in full contact with the ground of the vehicle. The display window
turns into a green colour.
6. Select a rear-facing recline position 5 (blue).
NOTE: For children of this size, the child seat must only be installed in the rearward
facing position and at a maximum angle of inclination (lying level). To make sure that
the car seat has been installed correctly, please shake it before use.
NOTE: Test by pulling on the child restraint to ensure it is locked.
FORWARD-FACING INSTALLATION
Children from 9 to 36 kg (groups I, II, III) can ride in forward-facing direction.
GROUP I (9-18 KG)
1. Place child restraint forward-facing (in the direction of travel) in proper seating location, flat on
the vehicle seat bottom and touching vehicle seat-back.
2. Press the ISOFIX button to pull out the two ISOFIX locking arms from the base bottom.
hear an audible CLICK! Ensure that the indicator turns into a red colour, which means ISOFIX
attachments are unlocked.
NOTE: The ISOFIX attachment points are located between the surface and the backrest of the
vehicle seat.
3. Align ISOFIX attachments to the metal anchorages at the bottom of the car seat's backrest and
push it until it clicks. You will hear an audible CLICK! Ensure the both sides of the ISOFIX locking
arms turn into green safety colour.
CAUTION: After the ISOFIX installation check if the child restraint is securely fitted. If the child
restraint is not stable and is shaking, reinstall.
4. Pull out the support leg, and adjust it to the maximum angle.
5. Press the adjust button of the support leg, and adjust the length of the support leg so that it is
in full contact with the ground of the vehicle. The display window turns into a green colour.
6. Select a forward-facing position from 1 to 4 (red).
GROUP II, III (15-36 KG)
NOTE: When using this child restraint in groups II or III, remove the 5-point harness, triangle
pad, and sleeping pad.
1. Place child restraint forward-facing (in the direction of travel) in proper seating
location, flat on the vehicle seat bottom and touching vehicle seat-back.
2. Press the ISOFIX button to pull out the two ISOFIX locking arms from the base bottom.
You will hear an audible CLICK!
means ISOFIX attachments are unlocked.
NOTE: The ISOFIX attachment points are located between the surface and the backrest of
the vehicle seat.
3. Align ISOFIX attachments to the metal anchorages at the bottom of the car seat's
backrest and push it until it clicks.
the ISOFIX locking arms turn into green safety colour.
CAUTION: After the ISOFIX installation check if the child restraint is securely fitted. If the
child restraint is not stable and is shaking, reinstall.
4. Fold the support leg by pressing the adjuster button and slide it inside.
5. The support leg should hang. The display window turns into a red colour.
6. Select a forward-facing position 1 (red).
7. First, pull out the belt from the belt ALR. Shoulder belt through the same side of
guidance 1, lap belt through the same side of guidance 3, then pull the shoulder belt
and lap belt together through another side of guidance 3.
8. To fasten the seat belt across child: lap portion of the vehicle seat belt should rest
within both lower belt guides with buckle located on the outside of the child restraint.
9. Place shoulder portion into the upper belt guide on the headrest so that belt lays properly across child: on the collar bone, interior
(A) to the shoulder (B).
10. Make sure seat belt is not twisted and remove slack from seatbelt so it lays flat, smooth and snug across child in all locations.
11. Fasten the vehicle seat belt. You will hear an audible CLICK! Pull the seat belt tight to make sure it is not twisted.
CAUTION: The shoulder seat belt section must run diagonally backward. You can adjust the course of the belt with your vehicle's
adjustable belt deflector on both sides.

SECURING THE CHILD

WARNING: If your child is not properly secured in the child restraint, they may be ejected in a crash, resulting in serious injury or death.
1. (For group 0+, I): Spread the 5-point harness straps apart.
2. Place your child in the child restraint in a seated position.
3. The child should be seated against both the back and bottom of the seat with no gap behind the child. Do not allow the child to slouch.
4. (For group 0+, I): Gently guide the child's arms through the 5-point harness loops.
the shoulder straps height. Straps must be well fitted and not twisted!
5. (For groups II, III): Pull the vehicle belt. Pull the vehicle belt. Route the lap belt portion under the armrests to the vehicle belt buckle.
Insert the 3-point vehicle belt in the buckle until you hear a click.
• A child restraint positions your child so that the seat belt fits across the strong bones of the hips and pelvis and not the abdomen, to
protect your child from injury.
• The shoulder portion of the seat belt should be positioned over the chest and collarbone, staying between your child's neck and
shoulder so that it does not touch the neck.
Ensure that the indicator turns into a red colour, which
You will hear an audible CLICK! Ensure both sides of
CLICK
green
CLICK
You will
A
B
CLICK
Insert the buckle tongues into the buckle. Check
EN
green
47