Securing The Child - NORAUTO 2274435-NO0538-AB810 Mode D'emploi

NOTE: Both shoulder belt and lap belt should be under the armrests.
GROUP III (22-36 KG)
NOTE: When using this child restraint in group III, remove the backrest. Please refer to the
ASSEMBLING, DISASSEMBLING, ATTACHING SEAT COVER.
1. Place booster seat forward-facing (in the direction
of travel) in proper seating location, flat on the
vehicle seat bottom.
2. To fasten seat belt across child: lap portion of the
vehicle seat belt should rest within both lower belt
guides with buckle located on the outside of the child restraint. Vehicle shoulder belt
must be routed above the armrest, lap belt must be routed under both armrests.
3. Place shoulder portion so that belt lays properly across child: on the collar bone,
interior (A) to the shoulder (B).
4. Make sure seat belt is not twisted and remove slack from seatbelt so it lays flat, smooth
and snug across child in all locations.
5. Fasten the vehicle seat belt. You will hear an audible CLICK! Pull the seat belt tight to
make sure it is not twisted.
WARNING: If lap and shoulder belt portions of seat belt and seat belt buckle are not all
correctly positioned, restraint is not properly installed as a booster seat.

SECURING THE CHILD

WARNING: If your child is not properly secured in the child restraint, they may be ejected in
a crash, resulting in serious injury or death.
1. Place your child in the child restraint in a seated position.
2. The child should be seated against both the back and bottom of the seat with no gap
behind the child. Do not allow the child to slouch.
3. Pull the vehicle belt. Thread it through the car seat slots to the vehicle belt buckle. Insert
the 3-point vehicle belt in the buckle until you hear a click.
• A child restraint positions your child so that the seat belt fits across the strong bones of
the hips and pelvis and not the abdomen, to protect your child from injury.
• The shoulder portion of the seat belt should be positioned over the chest and collarbone,
staying between your child's neck and shoulder so that it does not touch the neck.
CARE, CLEANING AND MAINTENANCE, STORAGE
• WARNING: It's dangerous to make any alterations or additions to the device without
the approval of the Type Approval Authority, also dangerous not to follow closely the
installation instructions provided by the child restraint manufacturer.
• WARNING: Do not attempt to disassemble the child restraint further than these
instructions allow.
• WARNING: All car seats expire. Plastic and metal parts wear out over time. Contact the
manufacturer if you are unsure when your seat expires.
A
B
CLICK
a
EN
37