Rear-Facing Installation - NORAUTO 2274270 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 3
2.
Take the gears fixed axle from the plastic stator and store it on the back of the backrest.
3.
Finally, insert redundant belt into cloth cover.
4.
To store a buckle,
press the straps release button to release the buckle tongues.
5.
Pull down the buckle cover.
6.
Lift the cover in the PE board and hide the buckle.
TRIANGLE PAD AND SLEEPING PAD REMOVAL
• CAUTION: When your child's weight exceeds 8kg, remove the triangle pad.
• CAUTION: When your child's weight exceeds 12kg, remove the sleeping pad.
SEAT COVER REMOVAL
1.
Set headrest in the highest position.
2.
Remove the 5-point harness.
3.
Remove the cover from the backrest and base.
4.
First, remove the cover from the base of the headrest, then remove the cover from the headrest.
To reattach the cover, reverse the above steps.
CAUTION: NEVER use a child restraint without a properly installed buckle.
CAUTION: Check that the harness straps are not twisted and that they are correctly inserted into the slots of the cover's straps.
INSTALLATION WITH VEHICLE SEAT BELTS
WARNING: If the child is not secured properly, the child could be ejected in a sudden stop or crash, resulting in serious injury or death.
WARNING: If in doubt about the installation, consult either the child restraint manufacturer or the retailer.

REAR-FACING INSTALLATION

It is recommended that children ride in a rear-facing child restraint
until they are at least 2 years old. An infant's head, neck, and spine
are not supported as well in a forward-facing position.
GROUP 0+ (0-13 KG)
1.
Place child restraint rear-facing in a compatible vehicle seat.
2.
Pull out the support leg, and adjust it to the maximum angle.
3.
Press the adjust button of the support leg, and adjust the
length of the support leg so that it is in full contact with the
ground of the vehicle. The display window turns into a green
colour.
4.
Select a rear-facing recline position 5 (blue).
5.
Pull the vehicle seatbelt and pass the lap belt section through the belt guidance 3 and under the sleeping cushion.
6.
Pass the shoulder seat belt section through the belt guidance 2.
green
green
EN
CLICK
45

Publicité

Table des Matières
loading

Table des Matières