Frozen Trace; Battery Charging; Data Transfer To A Pc; After Use - arjo HUNTLEIGH DMX Mode D'emploi

EN
6.3

Frozen Trace

Press at any time to return to the live trace screen.
To Save a trace:
To Open a Saved trace:
6.4

Battery Charging

• Only HR6 (NiMH) batteries can be charged. Check the battery type before connecting the charger.
• Do not attempt to recharge normal alkaline batteries. They may leak, cause a fi re or even explode.
• Only use the charger and USB lead supplied by Huntleigh.
• Switch off the Doppler before charging.
• Do not use the Doppler on patients when the charger is connected.
If the battery level is low, a
During charging, a
When fully charged, the symbol will change to
6.5

Data transfer to a PC

The Doppler does not contain patient information however, stored waveforms and data can be transferred to a
PC running Huntleigh reporting software, via the same USB socket as for battery charging. Consult your local
sales representative for details.
Note: Please observe the safety warnings in the Huntleigh software IFU.
6.6

After Use

Press and hold the On/Off button for one second to switch the unit off .
Refer to the cleaning section before storing or using the unit on another patient.
• Insert the supplied charger lead into the USB socket on top of the
Doppler.
• Connect the charger and switch on mains power.
Charging will take approximately 5 - 6 hours, depending on battery
status.
symbol will appear on the Status bar.
symbol will be displayed on the screen.
.