Setting Up The Power Supply; Charging The Udirect 2 - Unitron uDirect 2 Ensemble Guide

Setting up the power supply

1. Select the adapter that corresponds to
your country.
CAN EU
2. Insert the round corner of
the adapter to the round
corner of the universal
power supply until it is
completely inserted.
3. Click the tail of the adapter
in to lock it into place.
Make sure the adapter is securely locked.
To remove the power adapter:
a. Pull back the tab on the
universal power supply and
hold.
b. Gently pull the adapter upwards
to remove it from receptacle.
c. Then start over with step 1 (above).
4
UK AUS
2.
a.
Charging the uDirect 2
Your uDirect 2 has a non-removable
rechargeable battery.
To charge it:
1. Plug the mini-USB plug into the
mini-USB port on the uDirect 2.
2. Plug the power supply into
a power outlet.
Power indicator
Solid red:
3.
Solid green: Battery fully charged.
It is safe to leave the uDirect 2
connected to the charger overnight.
When charging your uDirect 2 for the first time,
let it charge for at least three hours, even if the
battery indicator is not lit or turns green earlier.
b.
A new battery's full performance is achieved
only after two to three complete charge and
discharge cycles.
Charging, typically
90 minutes.
5