Setting Up Bluetooth - Unitron uDirect 2 Ensemble Guide

Setting up Bluetooth

This section describes the pairing and
connection procedure for Bluetooth devices.
Step-by-step: pairing a Bluetooth-enabled phone
It is only necessary to perform the pairing
procedure once with each Bluetooth device.
The pairing procedure is controlled by your
phone.
Different phones have different menu
structures. You should, therefore, refer to your
phone's user guide or dealer support if you
cannot complete the pairing procedure with
the generic steps described here.
A maximum of 8 devices can be paired to the
uDirect 2. Another pairing will replace the first
device that was paired.
The uDirect 2 can support (connect) two
phones at the same time but only one call
at a time is possible.
For more information about Bluetooth pairing
instructions specific to some of the most popular
manufacturers, go to:
www.unitron.com
42
1. Turn ON your uDirect 2 and the phone. Place
them next to each other.
2. Locate the connectivity settings in your
phone menu. Look for the Bluetooth feature.
3. On your phone, ensure that the Bluetooth
feature is turned on.
4. On your phone, choose SEARCH to search for
Bluetooth devices or audio enhancements.
5. To initiate the pairing process on your
uDirect 2, press and hold the (
buttons simultaneously for 2 seconds until
the audio indicator starts to rapidly blink blue.
2 sec
6. Your uDirect 2 will remain in the pairing mode
for two minutes or until pairing is completed.
7. Your phone should present a list of Bluetooth
devices discovered. Select "Unitron
uDirect 2" from this list.
) and ( )
43