How To Wire Your Ceiling Fan - Emerson CURVA SKY CF145LBS00 Manuel Du Propriétaire

If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. All
wiring must be in accordance with National and
Local codes and the ceiling fan must be properly
grounded as a precaution against possible
electrical shock.
5.1
Position the Receiver into the Fan Motor Housing as
shown in Figure 10.
Refer to Figures 10 and 16 to connect the Receiver Wires
to the Supply Wires and the Fan Motor Wires using the
Wire Connectors, supplied with the Fan, as follows:
5.2
Securely connect the Ceiling Mounting Plate Green Wire
and the Supply Green Grounding Wire (this may be a bare
wire or a wire with green insulation) to the Fan Assembly
Green Wire using a Wire Connector (Figure 11).

5. How to Wire Your Ceiling Fan

CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan, light kit or receiver.
NOTE: Make all wiring connections using wire
connectors (supplied). Make sure that all connections
are tight, including ground, and that no bare wire is
visible at the wire connectors, except for the ground
wire.
Figure 10
Figure 11
Please contact 1-800-654-3545 for further assistance
9
FAN MOTOR
HOUSING
RECEIVER
SUPPLY GREEN
WIRE
CEILING
MOUNTING
PLATE GREEN
WIRE
WIRE
CONNECTOR
FAN ASSEMBLY
GREEN WIRE
RECEIVER
emersonfans.com
U.L. Model No.: CF145L & CF153L