Emerson CURVA SKY CF145LBS00 Manuel Du Propriétaire page 6

3. Ceiling Fan Assembly
3.4
Remove one of the three M4 x 10 mm Pan Head Screws
in the Lower Housing and loosen the remaining two
screws.
Retain the M4 x 10 mm Pan Head Screw for future use.
Tuck wires into the LED Light Fixture Assembly and
position in the Lower Housing Assembly.
Position the LED Light Fixture Assembly into the
Fan Housing by placing the cut out notches over the
Fan Housing Dimples (Figure 4).
NOTE: Make sure wires and terminals are positioned
under the LED Light Fixture Assembly and not
pinched between LED Light Fixture Assembly and
Lower Housing.
3.5
Rotate the LED Light Fixture Assembly clockwise on the
Lower Housing by engaging the two loosened screws onto
the key hole slots (Figure 5).
Secure the LED Light Fixture Assembly by tightening the
two M4 x 10 mm Pan Head Screws.
Reinstall the M4 x 10 mm Pan Head Screw that was
previously removed.
A spare M4 x 10 mm Pan Head Screw supplied in parts
bag, if needed.
You have now completed the initial assembly of your new
ceiling fan. You can now proceed with hanging and wiring
your fan.
(Continued)
M4 x 10 mm PAN
HEAD SCREW
Figure 4
Figure 5
6
LED LIGHT
FIXTURE
ASSEMBLY
CUT OUT
NOTCHES
DIMPLES
KEY HOLE
SLOT (2)
LOWER
HOUSING
M4 x 10 mm PAN HEAD SCREW
LED LIGHT FIXTURE
ASSEMBLY
LOWER
HOUSING
U.L. Model No.: CF145L & CF153L