Emerson CURVA SKY CF145LBS00 Manuel Du Propriétaire page 12

5. How to Wire Your Ceiling Fan
5.8
Remove and retain one of the four M5 x 10 mm Pan Head
Ceiling Cover Screws and Split Washers in the Ceiling
Mounting Plate.
Loosen the remaining three M5 x 10 mm Pan Head Ceiling
Cover Screws and Split Washers (Figure 17).
Unhook the Fan Motor Assembly from the Ceiling
Mounting Plate Hook and lift the Fan Motor Assembly up to
the Ceiling Mounting Plate.
Align and engage the Fan Motor Assembly slots with the
three Screw heads previously loosened by rotating the Fan
Motor Assembly to engage the Screw heads and all three
slots.
NOTE: Careful to capture both the M5 x 10 mm Pan
Head Ceiling Cover Screws and Split Washers on the
outer side of the Fan Motor Assembly.
Reinstall the previously removed M5 x 10 mm Pan Head
Ceiling Cover Screw and Split Washers (Figure 17).
Completely tighten all four M5 x 10 mm Pan Head Ceiling
Cover Screws and Split Washers.
A spare M5 x 10 mm Pan Head Ceiling Cover Screw and
Split Washer is supplied in parts bag, if needed.
WARNING
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling mounting plate and the
fan motor housing assembly.
5.9
Position the Ceiling Trim Ring over each of the protruding
M5 x 10 mm Pan Head Ceiling Cover Screw Heads and
rotate the Ceiling Trim Ring counter-clockwise to secure
(Figure 18).
CEILING
MOUNTING PLATE
Figure 17
Figure 18
12
(Continued)
M5 x 10 mm PAN HEAD
CEILING COVER SCREW
& SPLIT WASHER
FAN MOTOR
ASSEMBLY
M5 x 10 mm PAN HEAD CEILING
COVER SCREW HEADS & SPLIT
WASHER S (4)
CEILING
TRIM RING
FAN MOTOR
ASSEMBLY
U.L. Model No.: CF145L & CF153L