EIBENSTOCK EWS 225 Notice Originale page 19

The typical hand-arm vibration is below 2.5 m/s².
Measured values determined according to EN 60 745.
The declared vibration emission level represents the main applications of
the tool. However if the tool is used for different applications, with different
accessories or poorly maintained, the vibration emission may differ.
This may significantly increase the exposure level over the total working
period
An estimation of the level of exposure to vibration should also take into
account the times when the tool is switched off or when it is running but not
actually doing the job. This may significantly reduce the exposure level over
the total working period.
Identify additional safety measures to protect the operator from the effects
of vibration such as: maintain the tool and the accessories, keep the hands
warm, organisation of work patterns.
Warranty
According to the general supply conditions for business dealings, suppliers
have to provide to companies a warranty period of 12 months for
redhibitory defects. (To be documented by invoice or delivery note.)
Damage due to natural wear, overstressing or improper handling are
excluded from this warranty.
Damages due to material defects or production faults shall be eliminated
free of charge by either repair or replacement.
Complaints will be accepted only if the tool was returned in non-dismantled
condition to the manufacturer or an authorized service centre.
Declaration of Conformity
On sole responsibility we declare that this product is in conformity with the
following standards and standard documents:
EN 60 745, EN 55 014, EN 61 000,
according to the regulations 2006/95/EC, 2004/108/EC, 2006/42/EC
Elektrowerkzeuge GmbH Eibenstock
Lothar Lässig
27.10.2011
18