EIBENSTOCK EWS 225 Notice Originale page 17

Dust Extraction
Dust which appears during work is harmful to health. For this reason, use
an industrial vacuum cleaner while sanding.
The appropriate Wet/Dry Vacuum Cleaner DSS 25 A is available as
accessory. Directly connect it to the nozzles which are meant for it on the
dust hood.
Changing the brush rim
Connect the lead cable of the dry-wall sander with the industrial vacuum
cleaner and then connect the extraction hose with dust hood of the sander.
Lead the extraction hose and the cable to the back away from the machine.
Activate the switch-on automatic on the vacuum cleaner.
Switch the machine on and put it carefully on the surface you want to work
on.
Hold the machine with both hands and move it in a linear or rotary way.
For sanding works directly on wall edges you can remove a segment from
the protection hood. This allows working even on spots which are usually
hard to reach.
For this purpose, tilt the segment by
pressing on the clip.
In order to close the hood, position the
segment slightly inclined towards the
sanding disc. Both hooks of the segment
have to be placed behind the edge of the
straight part of the hook. Engage the clip
by means of a slight pressure.
Attention! For all other works you always have to work with the
complete protection hood!
!
Attention!
Do not touch rotating parts!
In case of wear of the brushes (extreme
amount of dust during sanding), the brush
rim has to be replaced.
For this purpose, pull the worn brush rim out
of the guide way and put the new one in the
flute which is meant for it.
Handling
16