EIBENSTOCK EWS 225 Notice Originale page 18

Care and Maintenance
Before the beginning of the maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance. However, the following points have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Environmental Protection
Raw Material Recycling instead of Waste Disposal
In order to avoid damages on transportation, the tool has to be delivered in
solid packaging. Packaging as well as unit and accessories are made of
recyclable materials and can be disposed accordingly.
The tool's plastics components are marked according to their material,
which makes it possible to remove environmental friendly and differentiated
because of available collection facilities.
Noise Emission
The indication of noise emission is measured according DIN 45 635, part
21. The level of acoustic pressure on work site could exceed 85 dB (A); in
this case protection means must be used.
Wear ear protectors!
Only for EU countries
Do not dispose of electric tools together with household waste
material!
In observance of European Directive 2002/96/EC on waste
electrical and electronic equipment and its implementation in
accordance with national law, electric tools that have reached
the end of their life must be collected separately and returned
to an environmentally compatible recycling facility.
17