EIBENSTOCK EWS 225 Notice Originale page 15

Make sure that the persons standing in the work area are not hit by
particles which fly around.
Keep the handles dry, clean and free of oil and grease.
During operation always hold the machine with both hands.
Caution! The tool still runs for a little while after the machine was
switched off.
For further safety instructions, please refer to the enclosure!
Electrical Connection
First, check the correspondence between voltage and frequency against
the data mentioned on the identification plate. Voltage differences from
+ 6% to – 10% are allowed.
The EWS 225 is made in protection class II.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small might cause a considerable drop in performance and an
overheating of machine and cable.
Switching on and off
Before connecting the machine to the mains supply, make sure that the
machine is switched off.
Short-Time Operation
Switching-on: press on/off switch
Switching-off: release on/off switch
Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage
the arrestor button
Switching-off: press the on/off switch and let it go off again
Attention!
In case of every stop of the machine or a power cut, the lock button
has to be released immediately by pressing the on/off switch.
Consequently, you can avoid an unintentional restart of the machine
(physical hazard).
The machine is equipped with an electronic switch. With this switch the
speed can be regulated according to the pressure on the button. Only use
the electronic switch when you want to start the machine slowly.
Permanent use with reduced speed can cause an overload because the
motor then gets less cooling air and therefore the machine will be
overheated much faster.
14