Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tool Change
Attention!
Before the beginning of all works disconnect the plug from
the mains!
Only use original accessories in order to allow an optimal extraction.
Changing the rubber foam pad and the base plate:
Rubber foam pad:
Base plate:
Attention!
Before you start working, check whether the accessory has the exact
position.
Let the machine start running in a safe position for a short time. In
case the machine does not run easily, immediately stop working.
Press the sanding paper in a way on the
rubber foam pad that the extraction holes
are not covered.
The 6 hole punch of both discs makes it
possible to centre exactly and to position
the sanding paper on the machine easily.
If existing, first remove the sanding paper
and then the rubber foam pad carefully.
When fixing the new pad, flange nut and
punched holes of the base plate make the
positioning easier.
Remove the nut in the middle of the base
plate by means of the enclosed face
spanner. If necessary, counter hold with a
screw driver in the work spindle.
15
Publicité
Table des Matières
