Power Outage - Vulcan VCS18 Manuel D'installation Et D'utilisation

POWER OUTAGE

If a power outage occurs, the unit will cease to function. When power is restored, the unit will automatically
resume normal functions if controls are still in an active configuration. In order to prevent damage or injury,
turn Selector Knob to OFF during the power outage. When power is restored, resume operation as normal.
The unit controls include a temperature sensor that will automatically stop the cooking cycle if high
temperatures are detected in the cabinet. In this event, the display will briefly show error code "EE1", then if
the overheat condition persists, it will show "EE2" and shut down the elements. The display will continue to
show the temperature of the tank, but all heating will cease. In order to reset the controls and resume
cooking, the unit must be allowed to cool sufficiently, then switched off before selecting the desired cooking
mode and setting the desired temperature. If this occurs repeatedly, the unit is in too hot an environment
and steps must be taken to isolate it from heat sources.
CLEANING
ENSURE THAT UNIT IS TURNED OFF AND POWER SUPPLY IS DISCONNECTED
BEFORE CLEANING.
DO NOT use Dawn® dish detergent to clean the unit. This detergent contains chlorine and is harmful to
stainless steel.
DO NOT use scouring powders. It is very difficult to remove completely and can cause build ups that will
damage the unit.
DO NOT use cleaning products containing TSC or sodium hydroxide.
All cooking components of the unit are stainless steel and should be cleaned thoroughly with warm water
and a mild detergent at the end of each cooking shift.
For changeovers from one cooking type to anther during a cooking shift, the degree of cleaning must be
commensurate with the needs of the cooking type. Cooked on debris can be scraped loose from the tank
surface with a spatula or scouring pad. Use only stainless or plastic utensils to avoid degrading the
stainless steel of the tank and unit body. Only use the built in water to rinse, DO NOT POUR WATER
ONTO THE UNIT using a bucket or other means.
Drain plug with attached trap should be removed and cleaned at least once per day. Take care not to damage
or dislodge the O-ring seal on the drain plug. Damage to the O-ring will cause the drain plug to leak.
If any spills occur inside the unit, immediately disconnect the unit from power and clean thoroughly. DO NOT
REMOVE THE PROTECTIVE COVER, doing so will increase the risk of electric shock or damage to the unit.
Use a squeegee or towel to push standing liquids through the drain hole into an acceptable receptacle or
drain and clean any stains or food items from the inside of the cabinet. Failure to do so can result in corrosion
or unsanitary conditions.
- 10 -