Specifications - DeVilbiss Healthcare DV55 Bilevel Série Mode D'emploi

EN
Problem Probable Cause
Air from flow 1. The air filter(s) is/are dirty.
generator
seems to be 2. The air inlet port is blocked.
too warm. 3. The room temperature is too
4. The SleepCube is located near
Nasal, sinus or You may have a reaction to air
ear pain, flow pressure.
possibly with
runny nose.
Bilevel changes 1. Trigger Sensitivity is not set
pressure too
early or too late
(not following 2. Backup rate (time) is too high,
breathing)

sPeCifiCaTions

Size . . . . . . . . . . . . . . . . . . . . . . . . 4.2" H x 6.5" W x 6.9" D (10.7 cm x 16.5 cm x 17.5 cm)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.7 lbs. (1.22 kg)
Electrical Requirements AC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100-240V~, 50/60 Hz
Electrical Requirements DC. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10.4 - 15 VDC, 5 Amps
Maximum Power Consumption . . . . . . . . . . . . . . . . . . 65 watts max from AC power source
Bilevel Pressure Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-25 cmH2O
Operating Temperature Range. . . . . . . . . . . . . . . . . . . . . . . . . . .41°F to 104°F (5°C to 40°C)
Operating Humidity Range. . . . . . . . . . . . . . . . . . . . . . . . . . 0% to 95% RH non-condensing
Operating Atmospheric Conditions . . . . . . . . . . . . . . . . . . . .Sea level to 8,500 feet (2600 m)
Storage & Transportation Temperature Range. . . . . . . . . . .-40°F to 158°F (-40°C to +70°C)
Storage & Transportation Humidity Range. . . . . . . . . . . . . . 0% to 95% RH non-condensing
Maximum Limited Pressure . . . . . . . . . . . . . . . . . . . . . . . . . . . .30 cmH2O under normal use
Sound Level (tested per ISO 17510) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 dBA
SE-DV56
26
high.
a heater.
correctly
the patient is breathing slower
than the backup rate
SpEcificationS
Remedy
1. Refer to the Cleaning section for
instructions on filter maintenance.
2. Unblock the air inlet.
3. Reduce the room temperature.
4. Locate the device away from the
heat source so the air being
drawn into the device is at room
temperature.
If the problem persists contact
your home care provider.
Discontinue use and contact your
physician.
1. Adjust the inspiratory and
expiratory trigger sensitivity to
adjust triggering for the patient
2. Reduce Backup Rate setting
(flow generator only)