DeVilbiss Healthcare DV55 Bilevel Série Mode D'emploi page 15

aDVancED mEnu controlS
Display Example
Tubing Length
1.8 m (6 ft)
Enable Menu
Press 
LCD Contrast Adj
50 %
Compliance Meter
123456.7 hours
Hourmeter
123456.7 hours
Firmware Version
V0.11 21/08/2009
Serial Number
KD123456
Adherence Score
83% (25/30)
SmartCode 1-Day
G201-0Y7-6GPH
Mode Description
The standard tubing length supplied with the

device is 6 feet (1.8 meters). However, you can
adjust your SleepCube to accommodate an air
supply tubing length of 10 feet (3.0 meters).
All
Replacement tubing can be obtained through your
home care provider (part numbers listed at the
end of this manual).
Pressing the down key enters the Enable menu.
All
Refer to next section for Enable Menu details.
This setting changes the contrast for the LCD
display. This only needs to be adjusted if you find it
All
difficult to see the display from your viewing angle.
The total number of hours (in 1/10 hour
increments) that the SleepCube has been providing
All
therapy. (while breathing hours)
The total number of hours (in 1/10 hour
increments) that the SleepCube has been in
All
operation.
Shows version of installed firmware.
All
Shows the serial number of the device.
All
Shows the maximum adherence achieved for any
All
period of thirty consecutive days of use within a
ninety-day time frame. The score represents the
percentage of days, within thirty consecutive days,
where usage met or exceeded the 'Usage
Threshold.'
SmartCode
reporting; therapy information is encoded in a
series of letters and numbers, and includes a
All
special character for error checking to ensure
accuracy. Use the UP arrow or DOWN arrow
keys to change the SmartCode reporting period.
is used for therapy management
TM
EN
SE-DV56
15