Turning The Appliance Off - Bertos G6F2B Mode D'emploi

92 |
This operation may be observed through the hole in the
oven floor. Keep the knob pressed down for about 20-30"
after ignition, so that the safety device activates.
Then adjust the thermostatic setting according to the
cooking programme required.
OPERATING INSTRUCTIONS
FOR ELECTRIC OVENS
TURN-ON AND TURN-OFF OF THE FE
TYPE ELECTRIC OVEN (Fig. 6)
By turning the selector switch (23) to the left or the right,
you can choose the type of cooking, heat above and/or
below. In either of these positions the green light comes
on (25 = live appliance).
By turning the selector switch (24) on desired position,
resistances are switched on, the warning light (26) comes
on and goes off when the selected temperature is reached
and the resistances switch off.
To turn the oven off, turn the thermostat into position ( )
EN
and the selector into position (O).
TURN-ON AND TURN-OFF OF THE FE1
TYPE ELECTRIC OVEN (Fig. 7)
In this type of oven the heat comes from the rear of
the chamber; it is, however, equipped with a fan which
distributes the heat evenly throughout the oven chamber.
By turning the selector switch (24) on desired position,
resistances are switched on, the warning light (26) comes
on and goes off when the selected temperature is reached
and the resistances switch off.
To turn off the oven, turn the thermostat to the off
position (O).
The first position of the knob corresponds to the fan
operation for cooling – defrosting.

TURNING THE APPLIANCE OFF

Turning the appliance off in an emergency
In case of malfunctioning, disconnect the gas and electric
power supplies from the appliances.
What to do in the case of malfunctioning or if the
appliance is not to be used for a long period
When the appliance is not to be used for a long time,
clean thoroughly and turn off both the gas and electric
supply. In the case of malfunctioning or failure, turn off
the gas supply and disconnect from the mains. Call the
service centre.
CARE OF THE MACHINE
ATTENTION!
- Before cleaning, turn the machine off and let it cool.
- For electrically powered machines, turn off the
disconnecting switch to cut off the supply of
electricity.
Careful daily cleaning of the machine ensures perfect
operation and long life. The steel surfaces are to be
cleaned with liquid dishwashing detergent diluted in
very hot water, using a soft cloth. For tougher dirt, use
ethyl alcohol, acetone or another non-halogen solvent.
Do not use abrasive powder detergents or corrosive
substances such as hydrochloric, muriatic, or sulphuric
acid. The use of acid may compromise operation and
safety of the machine. Do not use brushes or pads made
of metal or alloys which may cause rust stains.
For the same reason, avoid contact with iron objects.
Use caution with stainless steel pads and brushes which,
although they do not contaminate the surfaces, may
cause harmful scratches. If the dirt is stubborn, absolutely
do not use sandpaper or grinding paper. We suggest using
synthetic sponges instead, such as Scotch-Brite. Also, do
not use products for cleaning silver. Beware of the fumes
of hydrochloric sulphuric acid used, for example, to clean
floors. Do not aim jets of water at the machine, to avoid
damaging it.
After cleaning, rinse thoroughly with clean water and dry
carefully with a cloth.