Specific Instructions - Bertos G6F2B Mode D'emploi

ATTENTION!
The figures mentioned in the chapters "GENERAL WARNINGS", "GAS MODEL INSTRUCTIONS" and "ELECTRIC
MODEL INSTRUCTIONS" are shown on the initial pages of this manual.
APPLIANCE DESCRIPTION
Construction, equipment installed and safety devices
Robust steel frame, with 4 legs (adjustable in height).
18/10 chrome-nickel steel outer panelling.
GAS HOB
The heating capacity may be adjusted from the maximum
to the minimum through a gas safety valve.
The appliance is also fitted with a thermoelectric ignition
safety device (thermocouple).
The grids are in enamelled cast iron or stainless steel.
The burners are in brass, cast iron and aluminium.
OVEN
The cooking chamber is made in stainless steel.
The double-lined, heat insulated door has an insulated
handle and hinge with balanced spring.
The cooking chamber is insulated with glass wool.
Gas version
The burners are made to withstand thermomechanical
stress. The gas supply is controlled by a safety valve with
thermostat.
The main burner has a thermoelectric safety lighting
device (thermocouple).
Oven temperature may be set anywhere between 160 °C
and 300 °C by a thermostat.
FE Electric version
The resistances are placed in the roof (top heat) and floor
(bottom heat).
The temperature may be regulated between 50° C and
270° C by a thermostat connected to a three-pole switch.
The top and bottom resistances may be switched on
simultaneously or individually.
FE1 Electric (fan) version
The motor is located at the back of the oven at the centre
of the circular heating element.
The temperature may be regulated between 50° C and
270° C by a thermostat.
Warning lights indicate when the appliance is working and
the power is switched on.

SPECIFIC INSTRUCTIONS

MOD.
Qn
V kW:
The cooking chamber is in stainless steel.
There is no flue-gas collector in the cooker with an electric
oven.
Location
The appliance should be installed in a well ventilated
room, and if possible under a range hood.
The appliance can be installed on its own or alongside
other equipment.
If the appliance is to be installed near inflammable walls, a
minimum distance of 150 mm around the sides and back
should be allowed.
If this is impossible, take proper steps to ensure the
installation is safe, such as fitting tiles or heat-reflecting
material to the walls.
Before connecting up the appliance to the gas supply,
check on the data plate that the appliance is fitted for the
type of gas available.
If not, consult paragraph "Running the appliance on other
types of gas".
Legal and technical requisites
During assembly, the following legal and technical
requisites should be adhered to:
- relevant national legislation;
- local building and fire safety regulations;
- industrial injury legislation;
- local Gas Board regulations;
- current CEI regulations;
Assembly, installation and maintenance must all be done
by contractors authorised by the local Gas Board in
accordance with local and national legislation.
Before doing anything else, seek advice from your Gas
Board.
Installation procedure
To level the appliance correctly, adjust the height of the
four legs.
N°:
Hz: 50/60 IPX
ASSEMBLY
INSTALLATION
| 87
EN