Disposal - Dometic CA2500 Notice De Montage

Dometic CA2500
7.2.6 Adapting the connection shaft
Push the connection shaft (fig. 9 1, page 4) over the suction hole of
the roof air conditioner.
Caution – risk of damage
a
Do not shorten the end of the connection shaft which is pushed onto the
suction hole of the roof air conditioner.
Now measure the distance between the attachment unit and the bot-
tom edge of the connection shaft (fig. 9 2, page 4). The distance
must be approximately 36 mm. The connection shaft must be short-
ened accordingly if the distance is greater than 36 mm.
Note
I
Example of shortening the connection shaft:
Measured distance: 70 mm, required distance: approx. 36 mm
70 mm – 36 mm = 34 mm;
the connection shaft has to be shortened by 34 mm.
7.2.7 Installing the air outlet unit (fig. 0, page 5)
Caution – risk of damage
a
When attaching the suction head of the air outlet unit, make sure that the
screws are tightened with due care, to avoid overwinding. Jerking and
dragging on the suction head must be avoided, as it could come loose
from the intake hose.
Plug the 8-pole plug of the connection line between the device and air
outlet unit in the socket on the back of the air outlet unit.
Push the air outlet unit over the attachment frame.
Attach the air outlet unit to the attachment frame with the 8 counter-
sunk self-tapping screws (4.9 x 24) (included in the scope of deliv-
ery).
8

Disposal

Place the packaging material in the appropriate recycling waste bins
wherever possible.
Disposal
25