Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
•
Before working on the spray gun remove the power plug from the socket.
•
Cover areas that are
may transport paint mist over great distances and cause damage.
•
The units may only be used with a functional valve.
(fig. 1, item 19) do not operate the unit further! Dismantle and clean the ventilating
hose, valve and diaphragm and replace the diaphragm if necessary.
•
Do not lay the spray gun.
•
The device is equipped with a thermal release which disconnects the device in case of
overheating. In this case, turn off the device, remove the plug and let the device cool
down for at least 1/2 hour. Eliminate the cause of heating, e.g. bent hose, soiled air filter,
slots for air intake covered.
With original WAGner accessories and spare parts, you have the guarantee that all
safety regulations are fulfilled.
4. Description/ Scope of delivery
1)
Air cap
3)
Union nut
5)
Trigger
7)
Gun handle
9)
ON/OFF switch
11)
Carry handle
13)
Bottom section
15)
Closure
17)
Gun holder
19)
Ventilating hose
21)
Air hose connection
23)
Deposition tray for hardware
25)
Air filter
27)
Power cable
29)
Deposition tray for spray attachments
31)
Feed hopper
33)
Replacement nozzle seal *
* This is inside the container: remove it before starting operations!
26
not to be sprayed. When working keep in mind that wind, for example,
Description/ Scope of delivery (figs. 1+2)
WallPerfect W 867E I-Spray
if paints rises in the ventilating hose
2)
Nozzle
4)
Perfect Spray spray attachment
6)
Material volume regulation
8)
Air volume control
10)
Air hose
12)
Cover
14)
Main switch
16)
Container
18)
Valve
20)
WallPerfect I-Spray spray attachment
22)
Fastener for radiator/detail spray
attachment (accessory)
24)
Cover of air filter compartment
26)
Cable grommet
28)
Air hose retainer
30)
Stirring rod
32)
Practice poster
34)
Lubricating grease (without
illustration)*
Publicité
Chapitres
Table des Matières
