Cleaning And Storage - Beurer EM 70 Mode D'emploi

Key lock/unlock function
Press [PROG] and [ ] button together to lock the intensity setting
button in output status. The indicator [
the same buttons again to unlock the buttons.
Sound on/off function
Press [PROG] and [-] button together to switch off the remote con-
troller's sound. The [ ] will display on the LCD. Press [PROG] and
[+] button together to switch on sound.
3 4
5
6
7
Low battery indicator for main unit
8
When [ ] and [ ] display on LCD, the battery of the main unit need
to be charged as soon as possible.
Following completion of session
9
To turn off the device, press the [ ] button.
Remove the electrodes from the skin.
Remove the device from the electrodes. If you forget to turn off the
device for more than 3 minutes, the device will shut-down automati-
cally.
] will display on LCD. Press
34
If the device is frequently used during the day, it is advisable to
charge it before starting a new session.

10. Cleaning and storage

Cleaning the main device
1. Turn unit off. Remove Micro-USB cable if device has been charg-
ing.
2. Clean the device after use with a soft, slightly moistened cloth
and wipe gently.
• Do not use chemicals (like thinner, benzene).
• Do not let water get into the internal area.
NOTE
This device and accessories does not require sterilization.
Cleaning the electrode pads
1) Turn the power off
2) Remove pads from device.
3) Wash the pads when the adhesive surface becomes dirty and/or
the pads are difficult to attach.
Wash the pad softly with your fingertips under slow running cold
water for several seconds (do not use a sponge/cloth/sharp ob-
ject like a nail on adhesive side, do not use detergents, chemicals
or soap).
4) Dry the pads and let the adhesive surface air-dry completely (do
not wipe with a tissue paper or cloth).
CAUTION
• The life of pads may vary by the frequency of washing, skin condi-
tion, and storage state.
• If the pad no longer sticks to your skin or the pad is broken, imme-
diately discontinue use and obtain replacement pads as recom-
mended by the manufacturer.
• Before applying the self-adhesive electrodes, it is recommended
to wash and degrease the skin, and then dry it.
• DO NOT turn on the device when the electrodes are not posi-
tioned on the body.
• Never remove the self-adhesive electrodes from the skin while
the device is still turned on.