Use Of Medicinal Herbs, Oils And Other Aromatic Substances; Using The Nose/Mouth Steam Mask; Cleaning And Maintenance - Beurer FS 60 Mode D'emploi

Warning
The exiting steam is hot!
During the treatment, you should always turn the switch back to position "1".
Do not position your face too close to the mask, as otherwise the high intensity of the steam
can cause burns or redness.
When you want to stop using the device or the water has evaporated, turn the switch back
to position "0". The device's indicator goes out.
Rinse your face with cold water after use. Then apply a face cream or mask. The opened
pores let the active ingredients penetrate deep into the skin.
Do not use the facial sauna for more than 20 minutes per day. Using it 2–3 times a week is
recommended.

6.2 Use of medicinal herbs, oils and other aromatic substances

The aroma attachment enables you to use medicinal herbs, oils and other aromatic substan-
ces as part of an aromatherapy treatment. This is the best way for medicinal herbs, oils and
other aromatic substances that mix with the steam to exert their effect. However, no solu-
tions containing salt should be used.
Only use medicinal herbs, oils and other aromatic substances that are intended and suitable
for use with a steam mask and are licensed for this by the producer of these substances.
Use:
Open the lid of the aroma attachment. Put a few drops of the oil on a cotton wool ball. Put in
the cotton wool ball and then close the aroma attachment.
Important: Please do not fill fragrances directly in the water containers; this may cause
a fault in the device. Failure to comply will result in voiding of the warranty.

6.3 Using the nose/mouth steam mask

As the mucous membrane of the human nose is very sensitive, never use the device on
position "2" when using with the nose/mouth steam mask. Do not keep your nose too close
to the mask during use.
The treatment should not last more than 10 minutes per day and should be done 2–3 times a
week at the most.
Use as described under 6.1.

7. CLEANING AND MAINTENANCE

Unplug the device. Let it cool for about 10–15 minutes before taking the steam mask off the
basic unit by turning it anticlockwise. Empty the water container by holding it upside down.
Clean grease and chalk deposits after each use with a commercially available decalcification
agent suitable for aluminium.
Use a soft and slightly moistened cloth to clean the surface of the device and the steam
mask and then wipe the surface dry.
• Do not use harsh agents (e.g. alcohol, acetone, benzine or abrasives) to clean the plastic
parts.
16