Operation; Using The Facial Sauna; Use Of Medicinal Herbs, Oils And Other Aromatic Substances - Beurer FS 50 Mode D'emploi

Masquer les pouces Voir aussi pour FS 50:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13

7.1 Operation

Uncoil the cable fully. Place the device on a flat, firm, level and water-insensitive surface or on a
table.
Use the measuring cup to fill the device's water container with water. Do not exceed the maxi-
mum filling level.
You should never fill the container directly under running water but only use the measuring cup
that comes with it. The water volume at maximum filling level is enough for about 20 minutes use.
Do not use oils, herbs or other aromatic substances as a substitute for water but only added to
adequate water filling.
As well as the facial mask, there is also a special attachment for the nose.
Fix the desired steam mask onto the basic unit by turning it.
Ensure that the mask engages firmly with the knobs.

7.2 Using the facial sauna

Uncoil the cable fully. Plug into the socket. Then turn the switch clockwise until the red indicator
lights up. Turn the switch first to position "2" in order to speed up heating. After about 5 minutes,
steam begins to rise. Turn the switch back to position "1" to reduce the steam output.
Adjustable steam outlet:
You can also regulate the strength of the steam outlet by turning the steam disc.
When the steam outlet is closed, the steam comes out of the steam valve which is located on the back
of the device or mask. The water heating phase can also be shortened by closing the steam disc.
To avoid burns, never touch the steam outlet directly and ensure that the steam can come out of
the valve freely.
Now sit down in front of the device. Bend forward until your face is above the mask.
Warning
Do not hold the device in your hand and do not adjust it during operation until it has cooled down.
You could sustain burn injuries from hot water.
If the steam effect is perceived as too hot, increase the distance to avoid burns.
Warning
The exiting steam is hot!
During the treatment, you should always turn the switch back to position "1".
Do not position your face too close to the mask, as otherwise the high intensity of the steam can
cause burns or redness.
When you want to stop using the device or the water has evaporated, turn the switch back to posi-
tion "0". The device's indicator goes out.
Rinse your face with cold water after use. Then apply a face cream or mask. The opened pores let
the active ingredients penetrate deep into the skin.
Do not use the facial sauna for more than 20 minutes per day. Using it 2–3 times a week is recom-
mended.

7.3 Use of medicinal herbs, oils and other aromatic substances

The aroma attachment enables you to use medicinal herbs, oils and other aromatic substances
as part of an aromatherapy treatment. This is the best way for medicinal herbs, oils and other aro-
matic substances that mix with the steam to exert their effect. However, no solutions containing
salt should be used.
11

Publicité

Table des Matières
loading

Table des Matières