Beurer EM 70 Mode D'emploi page 33

Step 2 – Choose Treatment Body parts
Press [PROG] button to set the treatment body parts (Arm-Body-
Back- Joint-Leg). Switch between body parts by pressing [ +/- ] but-
ton. Selecting body part symbol is flashing. Press [PROG] to confirm
selecting body part.
Step 3 – Selecting treatment program
After confirmed the body part, you can set the treatment program
(Chronic-Acute-Relax-EMS). Switch between treatment program by
pressing [ +/- ] button. Selecting treatment program symbol is flash-
ing and body part symbol is continuous. Press [PROG] to confirm
program.
Step 4 – Start treatment and adjust intensity
Start the electrical stimulation by pressing [+].Adjust electrical stim-
ulation intensity by pressing [+] or [-] button.
NOTE
If there is any emergency happen, press [ ] button on remote con-
troller or press [ ] button on main unit to stop treatment.
Step 5 – Turn off the device
Press hold [ ] button for 2 seconds to turn off remote controller.
CAUTION
If there is no operation in the panel for 3 minutes, the remote con-
troller and main unit will be off automatically.
33