Receiving The Equipment; I.1. Checks On Receipt; I.2. Storage; Ii Installation - Vortice VORT NRG ECR Notice D'emploi Et D'entretien

ENGLISH
In compliance with the current standards, the machine should be installed only by technical personnel who are qualified
to work on equipment of this type.
Use the required personal protection equipment to avoid risk of injury from electrical, mechanical (injury from contact with
steel sheets, sharp edges, etc.) eye protection (UVC hazard; wear goggles to EN170) or noise hazards.
Do not use this equipment for any purpose other than that for which it is designed. This machine may be used exclusively
for the distribution of air that is free of hazardous substances.
The machine should be handled in accordance with the indications given in the relative section of this manual.
The machine must be connected to earth in accordance with the applicable regulations. Never start a unit that has not
been connected to earth.
Before carrying out any work on a unit, make sure that its is switched off and before opening panels or doors, wait until all
the moving parts have come to a stop (damper, fan and rotary heat exchanger).
During operation, all panels, inspection hatched and doors must always be fitted and closed. The unit must only be started
or stopped using the proximity switch.
Safety and control devices must not be removed, by-passed or deactivated.
When working on the unit, be aware that certain components can reach high temperatures (water coil or electric heater).
The system must be installed in accordance with fire prevention regulations.
All waste materials must be disposed of in accordance with the applicable regulations.
The manufacturer accepts no liability for damages ensuing from the incorrect use of the equipment, unauthorized repair
or modification, or failure to follow the instructions given in this manual.
I RECEIVING THE EQUIPMENT
Systems are supplied fixed to support feet and then wrapped in plastic film.

I.1. Checks on receipt

On receipt of the equipment, carefully inspect the packaging and the contents. If damaged, record an accurate description
of the damage on the delivery note.

I.2. Storage

The equipment must be stored in a dry enclosed area, at a temperature between -20 and 40°C; note that the packaging
does not offer sufficient protection against bad weather.

II INSTALLATION

II.1. Maintenance

The units must only be moved to their installation position.
If the equipment is handled using a fork-lift truck, ensure the forks support the load-bearing structure. Check that the load
capacity of the handling equipment used is suitable for the weight of the equipment received (refer to the weight data in
the manual).
If the equipment is handled using a crane, use 4 lifting ropes of the length indicated. The ropes must be at least as long as
the greatest distance between two attachment points.
SAFETY INSTRUCTIONS
9