Frame And Equipment Supplied; Installation - Vortice HRI-E ONE Notice D'emploi Et D'entretien

Masquer les pouces Voir aussi pour HRI-E ONE:
Table des Matières

Publicité

ENGLISH
• Keep the air intake and outlet ports of the appliance
free of obstructions, to ensure optimum air flow.
• Maximum operating temperature: 45°C.
• Specifications for the power supply must correspond
to the electrical data on ID plate A (Fig. 1).
• The electrical system to which the appliance
is connected must conform to applicable
standards.
The appliance must be installed by a
professionally qualified electrician.
A multi-pole switch must be used to install
the appliance. The contact opening gap
must be no less than 3 mm.
1 1
A

Frame and equipment supplied

The main parts of the appliance are:
• an outer casing of plastic fashioned in two halves, with
metal fastening plates;
• a polystyrene counterflow type heat exchanger,
featuring a special geometry designed to guarantee
the highest possible efficiency in terms of heat
exchange (up to 94%);
• two energy-saving variable-speed brushless motors (3
preset speeds);
• an electronic controller supervising the power input,
regulation and control of the appliance;
• two thermostat controlled actuators operating the by-
pass valve (One F model);
• remote control panel ("One F" model): the component
is packed in the electronic control box compartment
(accessed by opening the cover on the bottom of the
appliance);
• 4 temperature sensors;
• 2 x F5 filter
• 1 MODBUS cable
Key to air connections (fig.2)
2 2
B
A
A: Clean air outlet inside the room
B: Stale air intake from room
C: Fresh air intake from outside
D: Stale air outlet to outside

Installation

N.B. The appliance is not suitable for outdoor
installation.
The appliance must be installed in accordance with
current safety regulations in the destination country, and
with the instructions in this booklet.
The appliance must be fitted to an interior surface or wall
of the dwelling that is structurally sound enough to take
its weight (25 kg max).
Ensure that connections to the appliance are optimized
and simplified by strategic positioning of the electrical
interface, from which the wires emerge (fig.3).
3 3
C
D
17

Publicité

Table des Matières
loading

Table des Matières