Table des Matières
Publicité
ENGLISH
Ceiling-mounted installation
Various mounting options are available: Vortice
recommends fixing the appliance to the ceiling, using the
special brackets (purchased separately) (fig.4)
4 4
Condensate drain
During normal operation, condensate collects at the
bottom of the apparatus, in a double tray provided with
two drainage outlets.
The connection points are located on the bottom of the
appliance (fig. 5). The condensate drain can be provided
by connecting the drain outlets to two hoses with an
internal diameter of 19 mm approx.
To avoid the formation of air bubbles, create a siphon
trap in the hose connected to the outlet on the appliance
denoted 1, as illustrated in fig. 5b.
5 5
18
1
2
NOTE
In any event, after mounting the appliance, check that it
is perfectly level in order to ensure faultless operation.
The ducts used for conveying air must be of the correct
size.
Ducts to and from the outside must be thermally
insulated and not subject to vibration
The 125 mm standard diameter inlet and outlet ducts
must be secured to the corresponding ports of the
appliance by means of clips or other suitable fastening
systems.
If stale air is exhausted via the roof, the outlet must be
designed so as to prevent the formation of condensate
and the entry of rain water.
If fresh air enters via the roof, the intake must be
designed so as to prevent the formation of condensate
and the entry of rain water.
Cut the end of the hose skew.
NOTE
The siphon must be created observing the dimensions
indicated in fig. 5c; otherwise, correct operation of the
appliance cannot be guaranteed.
Condensate can also be drained off through the waste
plumbing system of the building.
5a
5a
1
2
Publicité
Table des Matières
