Turning Off The System; Changing The Settings - PIONEER DJ DDJ-800 Mode D'emploi

Play tracks
The following describes the procedure for outputting the sound of deck
1 (left side) as an example.
1
2
3
4
5
6
7
8
9
a
1 Channel level indicator
2 PHONO/LINE, DECK3, DECK1 selector switch
3 TRIM control
4 EQ (HI, MID, LOW) control
5 COLOR control
6 Headphones CUE button
7 HEADPHONES MIXING control
8 HEADPHONES LEVEL control
9 Channel fader
a Crossfader
b MASTER LEVEL control
1 Set the positions of the controls, etc., as shown
below.
Names of controls, etc.
PHONO/LINE, DECK3, DECK1 selector switch
TRIM control
EQ (HI, MID, LOW) control
COLOR control
Channel fader
MASTER LEVEL control
Crossfader
14 14
En
b
Operation
[DECK1] position
Turn it fully counterclockwise.
Center position
Center position
Move it downward.
Turn it fully counterclockwise.
Center position
2 Press the [PLAY/PAUSE f] button to play the
track.
3 Turn the [TRIM] control.
Adjust the [TRIM] control so that the channel level indicator's orange
indicator lights at the peak level.
4 Move the channel fader upward.
5 Turn the [MASTER LEVEL] control to adjust the audio
level of the speakers.
Adjust the level of the sound output from the [MASTER 1] and
[MASTER 2] output terminals to an appropriate level.
! To output sound from the speakers of the PC/Mac, adjust not
the [MASTER LEVEL] control but the volume of the speakers of
the PC/Mac.
Monitoring channel audio with headphones
Set the positions of the controls, etc., as shown below.
Names of controls, etc.
HEADPHONES MIXING control
HEADPHONES LEVEL control
1 Press the headphones [CUE] button.
2 Turn the [HEADPHONES LEVEL] control.
Adjust the level of sound output from the headphones to an appropriate
level.
Note
This unit and rekordbox dj include many functions to allow for more
individualistic DJ performances. For details on each function, access
the site below and see the "rekordbox Operating Instructions".
rekordbox.com/manual

Turning off the system

1 Close rekordbox.
2 Press the [u] switch on the rear panel of this unit to
set the unit to standby.
3 Disconnect the USB cable from the PC/Mac.

Changing the settings

! For details on how to change the settings of this unit, refer to
"Changing the settings" in the Operating Instructions.
Operation
Center position
Turn it fully counterclockwise.