Rehau RAUTOOL H2 Mode D'emploi page 28

5. Insert the joint fully into the clamping tool.
Caution:
Do not tilt. Tool must be applied over full surface and at right angles.
6. By operating the pump with the foot or the hand . . .
7. . . . force compression sleeve up to the fitting.
Caution:
Do not touch moving parts (risk of trapping fingers)!
8. Return tool to starting position by pressing release lever.
9. Completely compressed compression sleeve connection.
Processing at temperatures of under -10°C and over 45°C may
result in damage to the connection components, the tool and/or
people .
- Do not work below the minimum processing temperature of
10°C .
- At low temperatures (below 0°C), it is recommended that the
connecting components be pre-positioned in a warm envi-
ronment before processing .
28