Using The Tool - Rehau RAUTOOL H2 Mode D'emploi

rautool h2

using the tool

1. When fitting clamping jaws,
always push the long clamping
jaw on the tool cylinder first,
followed by the short clamping
jaw.
2. Use pins to fix the compressi-
on jaws.
Attention!
To ensure that the double clam-
ping jaws (for example size 25)
are aligned identically, always
insert the pins all the way.
pipe gripper, the
With the
compression sleeve can be held
when manufacturing vertical
cables. The pipe gripper also
serves to push back and hold
insulation or corrugated tubing,
in order to create the required
space to produce compression
sleeve connections.
26
3. The clamping jaws are
brought into the correct position
by turning the tool cylinder.
4. Rotating the swivel joint in a
tight installation situation can
make it easier to attach the tool.