Lenze Global Drive 8200 vector Instructions De Montage page 92

2 Safety instructions
General safety information
ƒ All specifications of the corresponding enclosed documentation must be observed.
This is vital for a safe and trouble−free operation and for achieving the specified product features.
The procedural notes and circuit details provided in this document are proposals which the user
must check for suitability for his application. The manufacturer does not accept any liability for
the suitability of the specified procedures and circuit proposals.
ƒ Only qualified skilled personnel are permitted to work with or on Lenze drive and automation
components.
According to IEC 60364 or CENELEC HD 384, these are persons ...
... who are familiar with the installation, assembly, commissioning and operation of the product,
... possess the appropriate qualifications for their work,
... and are acquainted with and can apply all the accident prevent regulations, directives and laws
applicable at the place of use.
Transport, storage
ƒ Transport and storage in a dry, low−vibration environment without aggressive atmosphere;
preferably in the packaging provided by the manufacturer.
– Protect against dust and shocks.
– Comply with climatic conditions according to the technical data.
Mechanical installation
ƒ Install the product according to the regulations of the corresponding documentation. In
particular observe the section "Operating conditions" in the chapter "Technical data".
ƒ Provide for a careful handling and avoid mechanical overload. During handling neither bend
components, nor change the insulation distances.
ƒ The product contains electrostatic sensitive devices which can easily be damaged by short
circuit or static discharge (ESD). Thus, electronic components and contacts must not be
touched unless ESD measures are taken beforehand.
Electrical installation
ƒ Carry out the electrical installation according to the relevant regulations (e. g. cable
cross−sections, fusing, connection to the PE conductor). Additional notes are included in the
documentation.
ƒ When working on live products, observe the applicable national regulations for the
prevention of accidents (e.g. BGV 3).
ƒ The documentation contains information about EMC−compliant installation (shielding,
earthing, arrangement of filters and laying cables). The system or machine manufacturer is
responsible for compliance with the limit values required by EMC legislation.
Warning: The controllers are products which can be used in category C2 drive systems as per EN
61800−3. These products may cause radio interference in residential areas. If this happens, the
operator may need to take appropriate action.
92
l
EDK82EV222 DE/EN/FR 13.0