Battery Status; Thorough Cleaning; Storage Case - Cembre B500ND Notice D'utilisation Et Entretien

Do not apply pressure to or stab at the touch button, a light touch using a bare fi nger is
suffi cient. The command pulse is sent when the fi nger releases the button.

2.8) Battery status

The battery is equipped with LED indicators that indicate the remaining battery life at any time
by pressing the adjacent button (P) (Ref. to Fig. 5):
4 LEDs illuminated: fully charged
2 LEDs illuminated: 50 % capacity
1 LED flashing: minimum charge, replace the battery
With the battery inserted in the tool, the remaining battery
life can also be checked on the display, via touch button
selection (Ref. to section 4).
The screen shown alongside indicates that the battery Voltage has
dropped below a minimum safety threshold; under these conditions the
tool will not start, and it is necessary to recharge or replace the battery.
The approximate time to fully recharge a battery is about 40 minutes.
2.9) Using the battery charger
Carefully follow the instructions in the battery charger user manual.
3. MAINTENANCE
The tool is robust, completely sealed, and requires very little daily maintenance. Compliance with
the following points, should help to maintain its optimum performance:

3.1) Thorough cleaning

Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any residue,
especially close to pivots and moveable parts.
Do not use hydrocarbons to clean the rubber parts.

3.2) Storage case

When not in use, the tool should be stored and
transported in the plastic case supplied to prevent
damage. The case, type VAL-P22, is suitable for stor-
ing the tool, the accessories, up to 9 die sets and
pre-prepared compression connectors.
VAL-P22: Size 465x315x116 mm (18.3x12.4x4.6
inches). Weight 1,5 kg (3.3 lbs).
9
min.
max.
BATTERY BATTERY
BATTERY