Battery Status; Thorough Cleaning - Cembre B35M-TC025 Notice D'utilisation Et Entretien

ENGLISH

2.7) Battery status

The battery is equipped with LED indicators that indicate the remaining battery life at any time by
pressing the adjacent button (P).
4 LEDs illuminated: Fully charged
2 LEDs illuminated: 50 % capacity
1 LED fl ashing: Minimum charge, replace the battery
2.8) Insertion/replacement of battery
To replace the battery, remove it by pressing the release button (15) (Ref. to Fig.2 page 24), then
insert the new battery, sliding it into the guides until it locks.
3. WARNING
T
HE TOOL IS UNSUITABLE FOR CONTINUOUS USE AND SHOULD BE ALLOWED TO COOL DOWN
FOLLOWING UNINTERRUPTED
A FULLY CHARGED BATTERY IN ONE SESSION
O
BSERVE RECOMMENDED REST PERIODS ALSO WHEN USING AN EXTERNAL POWER SUPPLY
D
O NOT USE THIS TOOL ON LIVE CABLES
P
ROTECT THE TOOL FROM RAIN AND MOISTURE
E -
LECTRO HYDRAULIC TOOLS SHOULD NOT BE OPERATED IN POURING RAIN OR UNDER WATER
3.1) Using the battery charger
Carefully follow the instructions in the battery charger manual.
4. MAINTENANCE
The tool is robust, completely sealed, and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance of the tool:

4.1) Thorough cleaning

Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any residue,
especially close to moveable parts.
,
SUCCESSIVE CUTTING OPERATIONS
,
DELAY BATTERY REPLACEMENT FOR A FEW MINUTES
.
. W
;
FOR INSTANCE
ATER WILL DAMAGE THE TOOL AND BATTERY
2
P
,
HAVING EXHAUSTED
.
.
.
.
6