Attachments; Supported Weight (Load) - IKA HS 260 basic Mode D'emploi

Attachments

Attachments recommended by IKA must be connected to the agitati-
on table to ensure safe and secure operation. in addition , the usable
weight and speed ranges shown in the diagrams (hatched areas) must
not be exceeded.
AS 260.1 Universal attachment
Universal, steplessly adjustable clamping cylinders make it posible to
adjust to any container shape.
The universal attachment consists of:
AS 1.60 basic suspension
AS 1.5 fastening screw
AS 1.61 clamping cylinder
ATTENTION: The base suspension of the universal attachment is
secured in place by four lateral clamping screwson the agitation table.
AS 260.2 Holding bracket adapter
With additional holding brackets (AS2.1, AS2.2, AS2.3, AS2.4 and
AS2.5) the holding bracket adapter is suitable foe working with round
flasks, measuring flasks and Erlenmeyer flasks.
Recommended / maximum fitting
AS 2.1 Holding bracket
AS 2.2 Holding bracket
AS 2.3 Holding bracket
AS 2.4 Holding bracket
AS 2.5 Holding bracket
ATTENTION! The holding bracket adapter is secured in place by four
lateral clamping screws on the agitation table.
AS 260.3 Dish attachment
For gentle agitation at low speed, for example for Petri dishes or
culture flasks. The dish attachments is equipped with an anti-slip
sheet that prevents the dish from moving around during the agitation
process.0
28
1x Dimension WxHxD
8x in mm
4x 425 x 135 x 334
12 / 12 Dimension WxHxD
8 / 9 in mm
5 / 8 330 x 24 x 334
4 / 4
2 / 4
ATTENTION! The dish attachment is secured in place by four lateral
clamping screws on the agitation table.
AS 260.5 Separating funnel attachment
For intensive agitation of sparating funnels.
Max. fitting:
6 x 50 ml Separating funnel
5 x 100 ml Separating funnel
3 x 250 ml Separating funnel
3 x 500 ml Separating funnel
ATTENTION! The separating funnel attachment is secured in place
by four lateral clamping screws on the agitation table.

Supported weight (load)

In order to ensure safe and secure operation, the agitator must only be
operated within the range of usable weight and speed (see diagram -
hatched area). Please make certain that the holding surface on which
the agitator is placed is clean and level. Otherwise the working range
shown in the diagram (the hatched area) cannot be used.
If the agitator is screwed together with an adjacent piece of equipment
(i.e. if it is integrated into a system) it should be noted during opera-
tion that dynamic forces may arise as a result of unfavorable loading
circumstances and the position of the center of gravity. This may cause
the adjacent equipment to vibrate or may cause the table to vibrate
uncontrollably. If you notice that the device is running unevenly, the
speed must in any case be reduced until the running irregularities no
longer occur.
Make certain that individual agitation vessels are placed in the middle
of the agitation table and multiple agitation vessels are place evenly on
the agitation table, and that all vessels are securely fastened in place.
Dimension WxHxD
in mm
410 x 33 x 370
Dimension WxHxD
in mm
228 x 95 x 234