IKA HS 260 basic Mode D'emploi page 25

a.) All display elements in the digital displays are activated for about 2
seconds.
b.) The device type (left display) and operating mode (right display) are
displayed for about 2 seconds.
2 6 0
K S
c.) IThe set time target value (for example 3:58) is displayed with
the indication h min and SV .The set (or stored) upper speed limit
from operating mode A is displayed with SAFE and OK for about 2
seconds. The display upper speed limit cannot be modified by pressing
and turning the turn button.
2 3 0
S A F E
O K
d.) The new speed target value that has been set or just stored in the
left display (for example 130) from operating mode A or B is then
shown with the unit 1/min and flashing SV .
I 3 0
I
/
m i n
SV
e.) by pressing the left or right turn button, you can place the agitator
in operation. the speed and time values are then shown in large format
on the display. In addition, the text
instead of SV .
The actual value of the time setting must be understood from this
point onward as the time remaining for the agitation process. If the
time remaining has reached zero, the agitator stops its motion.
I 3 0
Switching the operation mode:
C
The following steps are required to switch the operating mode:
a.) Turn off the device with the power switch.
4
b.) Hold down both turn buttons and turn on the device with the
power switch. After about 1 second, you can let go of the turn
buttons.
c.) It is not possible to switch between operating modes A, B
and C in any order. Instead, you can only switch by repeating
the steps above A - step a.) + b.) >B - step a.) + b.) >C - step
a.) + b.) >A - step a.) + b.) >
3 5 8 :
Setting the audio time expiration signal
i
n m i n
The following steps are required to activate the audio time expiration
SV 4
signal:
a.) Turn off the device with the power switch.
b.) Hold down the right turn button
and turn on the device with the
power switch. Let go of the turn
button after about 5 seconds.
3 5 8 :
c.) You can activate (SOUND ON) or
i
deactivate (SOUND OFF) the
n m i n
audio signal indicating that time
SV 4
has expired by pressing the right
turn button.
PV is shown on the display
3 5 6 .
3 5 8 :
I 3 0
I
/ i
m i n n
PV
SV
SV
SV
m i n
PV 4
25