Accessories; Environmental Protection; Technical Specifications - Metabo W 24-180 MVT Mode D'emploi

- Restart protection: The electronic signal
display (3) FLASHES and the machine does
not start. The restart protection is active. If the
mains plug is inserted with the machine switched
on, or if the power supply is restored following an
interruption, the machine does not start up. Switch
the machine off and on again.
- When switched on, the machine accelerates
to maximum speed very quickly, i.e. automatic
restriction of the starting current does not work
(soft start). An electronic error exists. Other
safety-related electronic functions are no longer
available. Have the machine repaired immediately
(see 11.).

10. Accessories

Use only genuine Metabo accessories.
Use only accessories which fulfil the requirements
and specifications listed in these operating
instructions.
Fit accessories securely. Secure the machine if it is
operated in a bracket. Loss of control can cause
personal injury.
See page 4.
A Wheels with an included hub
B Parting safety guard.
C Raised support flange
D Diamond discs (always use with safety guard or
parting safety guard attached)
E Adjusting nut (11)
F 2-hole spanner
G Roughing disc (always use with safety guard
attached)
H Louver disc (always use with safety guard
attached)
I Parting disc (always use with parting safety
guard attached)
J Parting safety guard with guide slot (place on
machine and secure with screws.) (with adapter
for connection to a suitable dust extractor for
extraction of stone dust generated when cutting
stone slabs.)
K Hand guard (for attaching under the additional
side-mounted handle.)
L Supporting disc for fibre discs (always attach
using the supporting disc clamping nut
supplied.) (always use with the hand guard
attached.)
M Fibre discs (always use with the hand guard
attached.)
N Steel wire brushes (always use with the hand
guard attached.)
O Bench cut-off stand
For the complete range of accessories, see
www.metabo.com or the main catalogue.
11. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.

12. Environmental Protection

The generated grinding dust may contain harmful
substances. Dispose appropriately.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.

13. Technical Specifications

Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
Ø = max. diameter of the accessory
t = max. permitted thickness of clamping
max,1
shank on accessory when using clamping
nut (11)
t = roughing disc/cutting disc:
max,3
max. permitted thickness of accessory
M = spindle thread
l = length of the grinding spindle
n = no-load speed (maximum speed)
I = Current at 120 V
120 V
HP = Horse power
m = weight without mains cable
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
For assessment purposes, please allow for breaks
and periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a = Vibration emission value (surface
h, SG
grinding)
a = Vibration emission value (disc sanding)
h, DS
K = Uncertainty (vibration)
h,SG/DS
Wear ear protectors!
ENGLISH en
11